Category B Combinations from
01/07/2008 |
|||||
Combination |
Question No. |
Show / Tell |
Question |
Answer |
|
1 |
B08 |
Show |
Show me how you would check that the direction indicators are working. |
Applying the indicators or hazard warning switch and check functioning of all indicators. (may need to switch ignition on, prompt not to start engine) |
|
1 |
B10 |
Tell |
Tell me how you would check that the brakes are working before starting a journey. |
Brakes should not feel spongy or slack. Brakes should be tested as you set off. Vehicle should not pull to one side. |
|
2 |
B05 |
Tell |
Identify where the windscreen washer reservoir is and tell
me how you would check the windscreen |
Identify reservoir and explain how to
check level. |
|
3 |
B02 |
Show |
Show me / explain how you would check that the |
If the steering becomes heavy the system may not be working properly. Before starting a journey two simple checks can be made. Gentle pressure on the steering wheel, maintained while the engine is started, should result in a slight but noticeable movement as the system begins to operate. Alternatively turning the steering wheel just after moving off will give an immediate indication that the power assistance is functioning. |
|
3 |
B12 |
Tell |
Tell me where you would find the
information for the recommended tyre pressures for this car and how tyre
pressures should be checked. |
Manufacturer’s guide, use a reliable
pressure gauge, check and adjust pressures when tyres are cold, don’t forget
spare tyre, remember to refit valve caps. |
|
4 |
B04 |
Show |
Show me how you would check the parking
brake (handbrake) for excessive wear, make sure you |
Apply footbrake firmly. Demonstrate by
applying parking brake (handbrake) so that when it is fully applied it
secures itself, and is not at the end of the working travel. |
|
4 |
B05 |
Tell |
Identify where the windscreen washer
reservoir is and tell me how you would check the windscreen |
Identify reservoir and explain how to
check level. |
|
5 |
B01 |
Show |
Open the bonnet, identify where you would
check |
Identify dipstick / oil level indicator,
describe check of oil level against the minimum/maximum markers. |
|
5 |
B12 |
Tell |
Tell me where you would find the
information for |
Manufacturer’s guide, use a reliable
pressure gauge, check and adjust pressures when tyres are cold, don’t forget
spare tyre, remember to refit |
|
6 |
B03 |
Show |
Open the bonnet, identify where you would
check |
Identify high/low level markings on header
tank where fitted or radiator filler cap, and describe how to top up to
correct level. |
|
6 |
B18 |
Tell |
Tell me how you make sure your head restraint is |
The head restraint should be adjusted so
the rigid part of the head restraint is at least as high as the eye or top of
the ears, and as close to the back of |
|
7 |
B07 |
Show |
Open the bonnet, identify where the brake fluid |
Identify reservoir, check level against high/low markings. |
|
7 |
B13 |
Tell |
Tell me how you would check the tyres to ensure |
No cuts and bulges, 1.6mm of tread depth across the central ¾ of the breadth of the tyre and around the entire outer circumference. |
|
8 |
B06 |
Show |
Show me how you would check that the horn is |
Check is carried out by using control (turn on ignition if necessary). |
|
8 |
B13 |
Tell |
Tell me how you would check the tyres to ensure |
No cuts and bulges, 1.6mm of tread depth across the central ¾ of the breadth of the tyre and around the entire outer circumference. |
|
9 |
B10 |
Tell |
Tell me how you would check that the brakes are |
Brakes should not feel spongy or slack. Brakes should be tested as you set off. Vehicle should not pull to one side. |
|
9 |
B14 |
Show |
Show me how you would clean the windscreen |
Operate control to wash and wipe windscreen (turn ignition on if necessary. |
|
10 |
B11 |
Tell |
Tell me how you would check that the headlights & |
Explanation: Operate switch (turn on ignition if necessary), then walk round vehicle. (As this is a "Tell Me" question, there is no need to physically check the lights.) |
|
10 |
B15 |
Show |
Show me how you would set the demister controls |
Set all relevant controls including; fan, temperature, air direction / source and heated screen to clear windscreen and windows. Engine does not have to be started for this demonstration. |
|
11 |
B16 |
Show |
Show me how you would switch on the rear fog |
Operate switch (turn on dipped headlights and ignition if necessary). Check warning light is on. Explain use. |
|
11 |
B19 |
Tell |
Tell me how you would know if there was a |
Warning light should illuminate if there is a fault with the anti lock braking system |
|
12 |
B09 |
Show |
Show me how you would check that the brake |
Operate brake pedal, make use of reflections in windows, garage doors, etc, or ask someone to help. (may need to switch ignition on, prompt not to start engine) |
|
12 |
B11 |
Tell |
Tell me how you would check that the headlights & |
Explanation: Operate switch (turn on ignition if necessary), then walk round vehicle. (As this is a "Tell Me" question, there is no need to physically check the lights.) |
|
13 |
B17 |
Show |
Show me how you switch your headlight from |
Operate switch (with ignition or engine on if necessary), check with main beam warning light. |
|
13 |
B19 |
Tell |
Tell me how you would know if there was a |
Warning light should illuminate if there is a fault with the anti lock braking system. |